Fsr FL-700 Bedienungsanleitung PDF herunterladen

FSR

METAL PRODUCT GROUP

FL-700 FL-710

The FL-700/710 ﬂ oor box is designed for conference rooms, auditoriums, classrooms, etc. where it may be nec-

essary to pass cables thru the box without interfering with the various connectors. This simpliﬁ es installation of

wiring when a group of boxes must be connected in series. The pass-thru route is front-to-back. The FL-700/710

water-tight carpet-trim cover is used with carpeted ﬂ oors over concrete. This ﬂ oor box provides a practical and

safe solution for easy access to cables and connector plates. The lift-off section of the cover allows full access to

internal cables and connector plates while a smaller, hinged trapdoor ﬂ ips back to create a cable exit. All cables

can be stored within the box when they are not in use, allowing unencumbered travel across the ﬂ oor in the area

of the FL-700/710.

Before proceeding with the installation please take time to review the photos on the opposite side of this

page.

Step 1

Locate the box, complete with the temporary cover, on the ﬂ oor structure. Remove the temporary cover, spacer

angles, and insert plate. Connect all conduits as required. Reinstall the temporary cover, spacer angles and insert

plate. Use the leveling feet to position the box such that the top of temporary cover is ﬂ ush with the surface of

the concrete ﬂ oor.

Step 2

After the concrete ﬂ oor is cured, remove the temporary cover, spacer angles, and insert plate. Install all the cables

and connector plates as required. Reinstall the insert plate, spacer angles, and the temporary cover.

Step 3

Prepare to install the ﬁ nish cover. Remove the temporary cover and spacer angles and discard them. Locate and

carefully seperate the outer and inner door ring gaskets.

Step 4

Apply the outer gasket to the bottom of the outer door trim ring, covering the trim screws, and ending up with an

1/8" overhang on the outer edges. Do not stretch the gasket while installing. The gasket should just touch the

edge of the attachment screw holes.

FSR Inc 244 Bergen Boulevard, West Paterson, NJ 07424

Phone: 973-785-4347 Fax: 973-785-3318 Web: www.fsrinc.com E-Mail: [email protected]

INSTALLATION INSTRUCTIONS

LIT1021A

11/08

1 2

FL-700 FL-710 1
2

Inhaltsverzeichnis

Seite 1 - FL-700 FL-710

FSRMETAL PRODUCT GROUPFL-700 FL-710The FL-700/710 ﬂ oor box is designed for conference rooms, auditoriums, classrooms, etc. where it may be n

Seite 2 -

Step 5Place outer door trim ring on top of the mounting plate insert and install all the screws. Use an alternate corner pattern to tighten.Step

Verwandte Modelle: FL-710

Kommentare zu diesen Handbüchern

Keine Kommentare

Fsr FL-700 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Ausrüstung Fsr FL-700 herunter. FSR FL-700 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Verwandte Modelle: FL-710

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Fsr FL-700